AcoSail/kernel_optimize_test
8
0
Fork 0
forked from luck/tmp_suning_uos_patched
Code Pull Requests Activity

ath5k: ignore the return value of ath5k_hw_noise_floor_calibration

Browse Source 
Noise floor calibration occasionally fails on Atheros hardware.
This is not fatal and can happen if there's simply too much
noise on the air. Ignoring the calibration error is the right
thing to do here, because when the error is ignored, the hardware
will still work, whereas if the error causes the driver to bail out
of a bigger configuration function and does not configure the tx
queues or the IMR (as is the case in reset.c), the hw no longer
works properly until the next reset.

Signed-off-by: Felix Fietkau <nbd@openwrt.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
This commit is contained in:
Felix Fietkau 2008-11-03 11:27:38 +01:00 committed by John W. Linville
parent 6d64360ac5
commit 8b0162a3dc
2 changed files with 2 additions and 6 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

4
drivers/net/wireless/ath5k/phy.c
View File

@ -2196,9 +2196,7 @@ static int ath5k_hw_rf5110_calibrate(struct ath5k_hw *ah,
return ret;
}
ret = ath5k_hw_noise_floor_calibration(ah, channel->center_freq);
if (ret)
return ret;
ath5k_hw_noise_floor_calibration(ah, channel->center_freq);
/*
* Re-enable RX/TX and beacons

4
drivers/net/wireless/ath5k/reset.c
View File

@ -842,9 +842,7 @@ int ath5k_hw_reset(struct ath5k_hw *ah, enum nl80211_iftype op_mode,
*
* XXX: Find an interval that's OK for all cards...
*/
ret = ath5k_hw_noise_floor_calibration(ah, channel->center_freq);
if (ret)
return ret;
ath5k_hw_noise_floor_calibration(ah, channel->center_freq);
/*
* Reset queues and start beacon timers at the end of the reset routine