Mariusz Bialonczyk f704938c0e w1: enable active pullup for DS2482 by default ... This commit enables the active pullup (APU bit) by default for the DS2482 1-Wire master. >From the DS2482 datasheet: "The APU bit controls whether an active pullup (controlled slew-rate transistor) or a passive pullup (Rwpu resistor) will be used to drive a 1-Wire line from low to high. When APU = 0, active pullup is disabled (resistor mode). Active Pullup should always be selected unless there is only a single slave on the 1-Wire line." According to the module author, Ben Gardner: "It doesn't look like active pullup would cause any hurt if there is only a single slave." And my tests with multiple and single slaves on 1-Wire bus confirms that. This active pullup can be manually disabled using the introduced module parameter: active_pullup = 0 Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>		2016-05-01 14:04:19 -07:00
..
ds1wm.c
ds2482.c	w1: enable active pullup for DS2482 by default	2016-05-01 14:04:19 -07:00
ds2490.c
Kconfig
Makefile
matrox_w1.c	Merge branch 'for-next' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/trivial	2015-09-01 18:46:42 -07:00
mxc_w1.c
omap_hdq.c	omap_hdq: fix usecount handling	2016-02-08 14:57:30 -08:00
w1-gpio.c	W1: w1-gpio - switch to using dev_pm_ops	2015-10-17 21:45:05 -07:00